MR-J4-T20 Mitsubishi AC Servo Manual PDF

1. For power supply specifications, refer to section 1.3.1.
2. MR-J4 servo MR-J4-T20 PDF amplifier has P3 and P4 MR-J4-T20 MR-J4-T20 Manual in the upstream MR-J4-T20 PDF of the inrush current suppression circuit. They are different from P1 and
P2 MR-J4-T20 Manual of MR-J3 MR-J4-T20 PDF servo amplifiers.
3. The power factor improving AC reactor can also be used. In this case, the power MR-J4-T20 Installation Manual factor improving DC reactor cannot be used.
When not using the power factor improving DC reactor, MR-J4-T20 Installation Manual short P3 and P4.
4. This is not used when the servo amplifier is in the J2S compatibility mode. MR-J4-T20 Installation Manual Always attach the short-circuit connector came with
a servo amplifier.
5. This is used to change the servo amplifier mode. Refer to section 13.1 for the mode selection procedure.
6. Use an external dynamic brake for this servo amplifier. Failure to do so will cause an accident because the servo motor does
not stop immediately but coasts at emergency stop. Ensure the safety in the entire equipmment. MR-J4-T20 Manual For wiring of the external
dynamic brake, refer to section 11.7.
>MR-J4-T20 MR-J4-T20 PDF Installation Guide Mitsubishi MR-J4-T20 PDF.